In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Sparks-R-Fun wrote:

Sending data serially is probably the most straightforward and common approach.  If you do this asynchronously (such as with the SX/B SerIn and SerOut commands) you can send values in one direction with a single signal wire and a ground connection.  

   If the chips are located far apart from each other you may want to use additional hardware to compensate for signal loss and noise.

 - Sparks

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=205586#m205592

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)