On 20/07/07, Denny Esterline <desterline@gmail.com> wrote:

> The obvious way is to create a new library part variant with the proper
> size, use the update libraries command, then use the change part tool - BUT,
> it sound like you're using the wrong part in the first place. If you're
> setting these into a 2x10 grid on 0.1inch spacings, that's not a wire pad,
> that's a pin header. I'd redraw the parts in the schematic using a 2x10 pin
> header from the pinhead library.

I see your point. For this project, however, I would not like to
redraw the schematics (it's a one-off project using a large
segment-LED). In the board-layout, I was thinking and searching for a
way to paint black polygons to conceal areas. Is there a way to do
this? That is, I'm going to paint a line large enough to separate the
wirepads so they won't short.


-- 
- Rikard - http://bos.hack.org/cv/
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist