I do not see in your code you disabling comparators, as per the datasheet: MOVLW H'7' ;Turn off MOVWF CMCON0 ; comparators 2007/6/28, Ariel Rocholl : > > Kevin's question is whether you use the ICD2 as a programmer or as a > Debugger. This is unrelated to the build mode. > > > 2007/6/28, Rikard Bosnjakovic : > > > > On 6/28/07, Kevin Timmerman wrote: > > > > > Are you using an ICD2 to program the PIC? If so, make sure to use the > > > Program menu in MPLAB, not the Debug menu. If the chip is programmed > > > with the debug executive, it will take control of RB6 & RB7 (program > > > clock and data). Also make sure LVP is not enabled, that would disable > > RB5. > > > > I'm using an ICD2-clone. Project->Build configuration (in MPLAB) is > > set to "release", and LVP is off. > > > > I forgot to include the code in the original post, so I'm attaching it > > here. > > > > > Use one resistor/LED. > > > And where are the values of all components ? > > > > Only one LED is on at a time, so there's no need to waste board-space > > by adding a resistor per LED. The LED-resistors (R2 and R3) are 220 > > ohms, all other resistors (pull-downs + MCLR) are all 10k each. > > > > > > -- > > - Rikard - http://bos.hack.org/cv/ > > > > -- > > http://www.piclist.com PIC/SX FAQ & list archive > > View/change your membership options at > > http://mailman.mit.edu/mailman/listinfo/piclist > > > > > > > > > -- > Ariel Rocholl > Madrid, Spain -- Ariel Rocholl Madrid, Spain -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist