In SX Microcontrollers, SX/B Compiler and SX-Key Tool, JonnyMac wrote:

Are you attempting to run the program in Debug mode so you can see the results of the WATCH directive?  If yes, you must remove the resonator and change the DEVICE setting of OSC4MHZ (internal) to OSCXT2 (external) so that the SX-Key can drive the chip; this is necessary so that Debug information can be sent back to the IDE from the SX.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=196685#m197450

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)