Try this place they have some very knowledgeable people there or can 
direct you to some one else.

http://www.eagle-plastics.com/
  Recon
Jake Anderson wrote:

> I've looked at silicons but i have no real idea on where to get them.
>
>The people i usually deal with are fiberglassers and epoxy is considered 
>a bit fancy for some of them. If you have any information on where one 
>could get sample kits and the like it would be greatly appreciated. I'm 
>familiar with the generic hardware store stuff and while its temperature 
>handling is fine its nowhere near structural enough. The "magic goo" 
>will be transmitting the torque from the motor windings to the mounting 
>(and hence the bot).
>  
>

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist