Richard Prosser wrote:
> Jake, How about non-acetic silicone rubber?
> Or a shellac type varnish that may leave you some air passages to push
> air through for cooling.
> Just a guess, I have not had this problem myself.
>
> RP
>   
I've looked at silicons but i have no real idea on where to get them. 
The people i usually deal with are fiberglassers and epoxy is considered 
a bit fancy for some of them. If you have any information on where one 
could get sample kits and the like it would be greatly appreciated. I'm 
familiar with the generic hardware store stuff and while its temperature 
handling is fine its nowhere near structural enough. The "magic goo" 
will be transmitting the torque from the motor windings to the mounting 
(and hence the bot).
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist