In SX Microcontrollers, SX/B Compiler and SX-Key Tool, transistortoaster wrote:

The SX has provision to calibrate the internal oscillator in the confguration bits. I think there are about 3 bits which will nudge the frequency. You would need to measure the output though with a frequency counter. It's a lot of hassle versus an external source which would be rated for 100ppm precision for the cheaper ones.

I don't know if you looked at all your IR receiver modules,  Digikey carries the Sharp line at low cost and high performance.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=195677#m195838

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)