In SX Microcontrollers, SX/B Compiler and SX-Key Tool, JonnyMac wrote:

Make your serial pin low for about 10 milliseconds before attempting the first SEROUT -- this will clear "junk" from the receiver UART.  If that doesn't work then you might want to put an inverter (MAX232) between the SX and your PC as it may not like the voltage out of the SX.  If you use an inverter you'll need to change to T9600.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=195343#m195347

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)