In SX Microcontrollers, SX/B Compiler and SX-Key Tool, smhhadima wrote:

I have a problem using:  serout rc.1, n9600,"a"
when I connect to my laptop serial port and run the hyperTerminal and set it for (9600, 8bit, no hardware control) I got wrong output

but when I change the hyperterminal setting to (9600, 7bit, no hardware control) it works (sometimes)

I used BS2 with the same command and it works fine

 

what is the problem in my SX setup?

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=195343

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)