In SX Microcontrollers, SX/B Compiler and SX-Key Tool, CCraig wrote:

This I2C program leaves the SDA line low after a read.

Sorry, you know how it goes, Sunday, only one chip to test with...etc. etc.

Is it a defective 24LC128 holding it low? It messes up the next read command.

My fix: do a HIGH SDA, even with lots of protection (resisters) has me worried even though its the only thing on the bus.

I don't know why the eeprom is not letting go. Ideas? until I can get a new chip to test.

Thanks, Chris

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=194306

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)