----- Original Message ----- 
From: "Victor Fraenckel" <victorf@windreader.com>
To: "PICMIT" <piclist@mit.edu>
Sent: Wednesday, May 30, 2007 7:39 AM
Subject: [EE] Part hunt


>I have searched all of the standard US distributors (Digikey, Newark,
> Mouser and Jameco) for a Molex Milli-grid (2mm pitch dual row) wire to
> pcb IDC 20 pin connector. I believe the Molex part number is 8756820xx.
> This part appears to be obsolete. I have a small GPS module which has
> the matching connector for interface to the power and signals. I would
> like to get the boards into service. I have 10 boards so would need 10
> of the connectors. I would not like to solder the wires directly to the
> on-board connector. Any suggestions as to where else I might look or
> what I might use?
>
> Any enlightenment will be appreciated.
>
> Vic
> -- 

Vic,

The Molex site still shows these in their catalog ( 
http://www.molex.com/cmc_upload/common_files/12182003_152001_milli.pdf ), so 
may not be obsolete. The site also lists several U.S. distributors, other 
than those you mentioned.

Good luck.

Richard

. 


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist