Redwood Shores, 11 mei 2007.

I'm using the A/D converter at the moment for a temperature sensor, and it
accurately reads all 10 bits of the temperature (this is good, as it has a
10mV/K difference. This means at 5V each bit is about half a degree). Almost
always the result is identical to the temperature in the room (as given by
my thermostate). However, occasionally it starts to oscillate between the
correct value and a value that is 10 degrees higher. I doubt this is caused
by the lack of resolution, though: most likely it is a true oscillation in
the voltage. As it only happens occasionally, it is rather hard to debug
(it, of course, never happens when it is hooked up through the PICkit 2).

Greetings,
Maarten Hofman.
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist