> What is your target cost?

A few dollars or less for a set of 4. Like $0.50 or $1 per cable. Maybe as
much as $1.50 each.

> Are your boards already fabbed implying you must go with 
> whatever they are laid out for? 

The daughters are, the main board could be changed, but since it has to
match...

> Or can you adapt to something else?

There really isn't room on the daughter board to put anything other than a
1x7 header

> If they are already fabbed, what is the connector pitch? 1.25mm? 2mm? 
> 2.5mm? .1"?

0.1" aka 2.54mm. 1x7 standard pin header

> I have had some success for hobby stuff hitting the surplus 
> outfits - Allelectronics, etc., who often have assembled 
> cables in stock, at least for quantities up to 100.

Holy poop! There it is:
http://www.allelectronics.com/cgi-bin/item/RJ-57/126/7_PIN,_5"#34;_JUMPER_ST
RIP_.html Now if I can just figure a way to make one end into a female so
the daughter boards can be unplugged as need be...

---
James Newton: PICList webmaster/Admin
mailto:jamesnewton@piclist.com  1-619-652-0593 phone
http://www.piclist.com/member/JMN-EFP-786
PIC/PICList FAQ: http://www.piclist.com


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist