In SX Microcontrollers, SX/B Compiler and SX-Key Tool, peterverkaik wrote:

Bean,
Today I used a 10 meters long coaxial cable (75 ohm) with the two-resistor setup.
I didn't notice any difference with the short cable I used before.

To answer your other question: I am designing a new javelin board that incorporates
an sx18. Since I have a few pins left I thought it would be nice to include a video
output.

I noticed your overlay board uses a LM1881 to detect the horizontal sync.
Have you seen this page:
[url=http://www.sxlist.com/techref/ubicom/lib/io/dev/video/hsync-ng.htm]http://www.sxlist.com/techref/ubicom/lib/io/dev/video/hsync-ng.htm[/url]
If you have, and rejected that approach (or perhaps tried to follow it up)
could you tell if it is feasible? I rather not spent time on it if you already
tried it with no success.

regards peter

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=187393#m187741

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)