In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Peter Van der Zee wrote:

Hi All;

Phil that could easily be done (once the interface is built) by mounting it on my CNC mill, and have the mill head push the caliper ahead half a thou under CNC program control, then read the output of the caliper, and loop back until all 6, 8 or 12 inches are covered.

A little bit of work, but not too bad. After I get the interface figured/built, I have a stab at this.

Very interesting......

Cheers,

Peter (pjv)

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=186476#m187181

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)