In SX Microcontrollers, SX/B Compiler and SX-Key Tool, mwkohler wrote:

I am using SX/B with an SX28.  I am trying to send 5v from any port using the following code:
 

rc.3=pinc(1)

Output rc.3

pinc(1)=1

 

I can only get about 1 volt signal however if I change this to the following code I can get 5 volts.

 

High rc.3

 

Why does this happen?

 

I want to be able to define pins with variables so that I can use a for next loop to control them.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=185293

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)