On Friday 13 April 2007 12:01, Vasile Surducan wrote:
> There is an ulp (available only in some newer versions of Eagle) you must
> run. It's been a while I've used Eagle so I forgot the name but I think is
> drill-legend.ulp
> This one will assign a predefined symbol to every via or hole you may
> have (and for about 2000 vias will take a few minutes).

I don't have that one, but I'll check their website.  Perhaps you mean 
drill_cfg.ulp?  I use this one first to generate a table of drill sizes, then 
the CAM processor expects this table.  Sounds similar to what you're 
referring to.  But it generates a codename (such as T01, T02, etc) to each 
hole size, not for each hole instance.


> Also will draw a table containing the legend. I'm not sure if you have
> to write manually which drill symbol is plated or which is not in this
> table.
> On Mentor's Pads this is done automaticaly on every layer and you
> could easily select the drill type for every drill drawing file. So
> you may have one drill drawing for plated and other drill drawing for
> non plated drills. AFIR on Eagle this is not possible (unless some new
> ulp has been created).

I'll have to see if I can find anything else on this file thru google.

Cheers,
-Neil.
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist