In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Rsadeika wrote:

I am running into a problem that I can not figure out how solve. If you take the example code, UART_SIRCS.SXB, and just change the values so it will run on an SX52 proto board, it will not run correctly. The program runs correctly on an SX28 chip, but not on an SX52 chip. Now, after playing around with the code for a couple of days, I am getting the feeling that the way the varibles are set up, some of them are getting washed out. Which means the program will not run correctly, that is just my guess.
 

The only thing that I did was change the device to SX52, OSCXT2, BOR42 in the UART_SIRCS.SXB program. Anybody else having this problem, or do I have to do some other changes to the program to make it work on an SX52 chip. Any ideas or comments.

 

Thanks

 

Ray

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=182347#m182628

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)