In SX Microcontrollers, SX/B Compiler and SX-Key Tool, DosManDan wrote:

Thanks! I'll have to look those over at home. I had considered the RAPU, but I wanted to see if I could make one myself. If not, that will be my fallback plan.

One of the EFX guys posted some ISR code and I'm looking over it deciding if I can use some portions of it on my controller.

I'd be willing to work with you on the software you mentioned. I'm a Sr. Software Engineer, with about 20yrs experience. I realize I'm going to need a way to record all the movements and transfer them to the EEPROMs. Considered building a small controller with a ZIF socket, a rotary selection dial and slider switch. I can select the servo number using the rotary dial, then set the position with the slider and save all servo positions to the EEPROM when I push a button. Of course, I can eliminate the rotary dial and just use 6 sliders instead. Or, we can write software and make this waaay easier  ;-)

 

Is the EFX SX prop controller out yet? I checked a while back and they said it was comming soon. 

 

I've looked at Express PCB, if you are happy with them, guess I can give them a try too. 

 

Thanks again,

Dan

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=180020#m180067

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)