Hi all,
 I'm having trouble programming a 10F206 with my easyprog
programmer. I know it works, because I can successfully
erase, program and verify a 12F683.

I measured a VPP of 13V, a valid VDD (tried 4.5V and 5V)
using the pic_ctrl program. Clock and data lines also act
normally.

To give some context : I had just soldered a 10F206 (SOT23)
on a breakout board, and first of all I dumped its memory
content to get the OSCCAL value. Then, I almost managed to
program it once. If I remember correctly, it failed
verification during the programming cycle.

Now, though, whether I try to read or program the PIC, or
just do a dry-run (pic_prog -PIC 10F206), it tells me "Target
chip is not a 10F206 or one of its variants". I know the 10F
PICs don't have a device ID, so I really don't know what's
wrong. Could it be I over-wrote some critical config the first
time?

Thanks,
Christian
-- 
  CSB
  csb_cbw@fastmail.fm

-- 
http://www.fastmail.fm - mmm... Fastmail...

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist