In SX Microcontrollers, SX/B Compiler and SX-Key Tool, peterverkaik wrote:

The attached version runs (SX48) , generating "RESET" followed by a stream of digits.
'0' for task0, '1' for task1 etc.
Just set pinTX to I/O port of choice and connect via level shifter to pc com port.
Baud 9600,8N1.

There is one issue, task7 never runs. Actually, the task initially at entry7 (=task7) of the
tasklist never runs. Have not figured out yet why that is.
My simulation showed task7 does get to run.

regards peter

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=3&m=157842#m176353

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)