I'm wondering if there's a way to use some lines of program code to pre-load various EEPROM locations in an 18F452, in the same way that configuration bits can be pre-set using __CONFIG.  I've been using Modify under the Window menu in MPLAB each time I burn a chip, but it doesn't save my settings with the project.  I can't seem to find what I'm looking for in the manual, probably because I'm a bit sketchy on the correct terminology.  I'd be grateful if someone could steer me in the right direction.

Many thanks,
RR   
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist