In SX Microcontrollers, SX/B Compiler and SX-Key Tool, ellizard wrote:

HI Bean,
Sorry for stealing your time

BUT ! 

For wath i read about multifunction timers on SX48
I could not understand much....

how i connect the pins for: start the timer with a software start, at a stop signal from a comparison vs a ref voltage, store somewhere the elapsed time.
do some other computing, start again the process.........................

I'm confused by the description of software timer mode, capture/compare mode, it seem to me that there are described only the minimum information,
Gunther's book reports roughly the same as the sx48 datasheet reports, the same in the sx-key manual and in Al Williams's book.

No example schematic, to start with..

Searching in the forum lead me to very high topics on the subject, too high for me?
As you could understand I'm not exactly a guru in programming (probably the opposite).

Give me a startup

Saluti
Stefano

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=170635#m171157

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)