Harold,

Try adding more 0.1uf caps and make sure WDT in config fuse
is off.

Andre

 

-----Original Message-----
From: piclist-bounces@mit.edu [mailto:piclist-bounces@mit.edu]On Behalf
Of Harold Hallikainen
Sent: Thursday, February 08, 2007 11:56 AM
To: Pic List
Subject: [PIC] ICD-2 Intermittently showing PC and Locals


I'm running an ICD-2 (R23.1) on MPLAB 7.51 on a 24hj256gp610. The ICD
seems to program the chip and recognize breakpoints fine. However, most of
the time, when I hit a breakpoint, the "little green arrow" showing where
I am in the source code does not appear, locals do not appear, and the
watch list is not updated. If I hit F7 or F8 to step through the program,
it APPEARS to be stepping (a message on the bottom of the screen says it
is), but the green arrow still does not appear. This is intermittent. I
can close MPLAB and re-open it, and it may work for a while, then stop.

IDEAS? Debugging this way is difficult!

THANKS!

Harold


-- 
FCC Rules Updated Daily at http://www.hallikainen.com - Advertising
opportunities available!
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist