In SX Microcontrollers, SX/B Compiler and SX-Key Tool, GKris wrote:

Hi everybody! . I'm also working on CMUcam2 vision sensor. I accidentally mounted the camera in the inverted position on the vision board, then turned it on. so the red LED was on. I turned it off immediately after realizing it was inverted..I turned it on again  and then connected it to the serial port..It was detected in the hyperterm..Does it mean there was no hardware damage caused by the inverted mounting of the camera? Your help will be so much appreciated..Thanks...

GKris

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=170147

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)