In SX Microcontrollers, SX/B Compiler and SX-Key Tool, g_daubach wrote:

Hey Folks,

what do you think about a plain "straight-through" adapter for the SX48 with no additional components but the SX48, and four filter caps for the supply voltage on a two-layer board with ground planes on both sides (not shown in the attached picture).

This is only a draft - I don't have the board yet; but may need to have it manufactured for one of my projects in larger quantities. I was also thinking about a 48-pin DIL-shaped carrier but this one would require more real-estate on the mother board than the square format which is about 1.5" each side.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=166781#m166918

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)