Here's a little bit of code I wrote to disable the Timer 1 oscillator
on the 16F88:

banksel T1CON			; Attempting to disable Timer 1 oscillator
movlw b'00000100'
movwf T1CON		

Does that code look like it'll work?  This actualy relates to my
stability problems earlier.  I have found that pulling RB6 and RB7 low
seemed to help the chip run.  Noting on the datasheet that these pins
are both related to the Timer 1 module, I was wondering if disabling
it might help this condition.  Or, are there better methods of
handling this without adding external components?  I would very much
like it if I could leave the unused pins unconnected(I'm breadboarding
this, and would end up buried in resistors:P )

-- 
Paul Anderson
VE3HOP
wackyvorlon@gmail.com
http://www.oldschoolhacker.com
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist