On Jan 10, 2007, at 10:21 AM, Vasile Surducan wrote:

> which is the maximum component density
> you may route using the Eagle's autoroute facility on an 100x50mm
> board with say 10 layer padstack.

I don't think there's any inherent density limit on the autorouter;
it will go down to the usual design limits supported by board houses.
However, as people have said previously, it's NOT a very good
autorouter, and I expect you wouldn't be happy with it at very high
densities.

> No one said the freeware Eagle can't be used.
>
Freeware eagle only supports two layers, so there goes your 10 layer
padstack...

BillW
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist