On 1/8/07, Bob Blick <bblick@sonic.net> wrote:
> Hi Paul,
>
> Not an Eagle-specific tip, but:
>
> Make copies of the library parts you are going to use, and change the
> pad types of your through-hole parts to "annular". That's the type of
> pad that has a hole in the center. When you drill the board, it'll act
> like a center punch and keep the drill bit centered.

Yes, I do the equivalent on Eagle, but for the whole board...

In the board editor, under the Options/Set... menu item, select the
Misc tab and select the Real button under Display mode (the
alternative is No drills).

Orin.
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist