Hi Paul,

Not an Eagle-specific tip, but:

Make copies of the library parts you are going to use, and change the 
pad types of your through-hole parts to "annular". That's the type of 
pad that has a hole in the center. When you drill the board, it'll act 
like a center punch and keep the drill bit centered.

Cheerful regards,

Bob


Paul Anderson wrote:
> I probably have this miscatagorized, and apologize if this is so.  I
> have EAGLE Lite 4.16r2, and I've been working with getting a feel for
> it.  Does anyone have suggestions for using EAGLE to produce PCB
> artwork that I can etch myself?
> 

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist