Hi folks,

I am building a circuit that needs to monitor the 3 phases in the mains, and 
detect if (a) any one phase fails, and (b) if the phases are connected 
improperly.

After some search I found 
http://www.picbasic.org/forum/archiv...hp/t-2134.html to be pretty close to 
what I need.

What would be the best way to go about it?

Would this logic work?

Detect positive edge on phase 1
Start Timer 0
Detect positive edge on phase 2
Read Timer 0 as variable 1
Detect positive edge on phase 3
Read Timer 0 as variable 2
Stop + Reset timer
If Variable 1 is equal to (almost) = (Variable 2)/2 = 6.67 ms (for 50 hz) 
then all is ok.

Start again.

Am I on the right track, or is there a better/easier way to do this?

Regards,

Anand 

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist