In SX Microcontrollers, SX/B Compiler and SX-Key Tool, originator99 wrote:

I think someone should look at this datasheet info,  the pins on the pad should fall midway when centered on the pads.  The datasheet shows the outside to outside pin dimensions as 7.80mm, but the pad spacing(center to center) as 6.858 which means the pins will really fall way to close to the edge if not over the edge.  The SX's I have are running on the large size of the tolerance, so the layout shown is too small on the acual pcb.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=163564

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)