Hi,

I am having trouble running the ICD 2 debugger with PIC18LF1320 target.
Currently running MPLAB 7.51 and Hi-Tech C compiler v9.5 PL3.

All other projects work fine with the debugger (mainly PIC18LF2520 and 
PIC18LF6720).

Debugger -> Settings -> Status shows all pass and correct Vpp and Vdd.
In the configuration bits I have selected RC internal oscillator with 
port pins on RA6,RA7.
I have Not enabled power up timer or watchdog timer or low power 
programming.

In the code I set OSCCON to 0x60 for 4 MHz internal clock.

When I select Debugger -> Program, the following messages are shown.

*************
Programming Target...
...Validating configuration fields
...Erasing Part
...Programming Program Memory (0x0 - 0x1E3F)
...Loading DebugExecutive
...Programming DebugExecutive
...Programming Debug Vector
...Programming RSBUG
Verifying...
...Program Memory
...Debug Executive
...Debug Vector
...Verify Succeeded
Programming Configuration Bits
.. Config Memory
Verifying configuration memory...
...Verify Succeeded
Connecting to debug executive
...Programming succeeded
22-Dec-2006, 07:04:59

MPLAB ICD 2 Ready
*****************

When I attempt to RUN, the following messages are displayed.

**************
ICD0154: Invalid target mode for requested operation (TM = Running)
Running Target
ICD0154: Invalid target mode for requested operation (TM = Running)
ICD0069: Debug:  Unable to run target
ICD0154: Invalid target mode for requested operation (TM = Running)
ICD0151: Failed to sync memory (MT = Data) (Dir = 0x0)

*****************

I have spoken with both Microchip technical support(Sydney) and Hi-Tech 
engineer but neither has been able to offer a solution or reason why 
this would occur.
Any help much appreciated. Thanks

Regards

David
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist