In SX Microcontrollers, SX/B Compiler and SX-Key Tool, kehnan wrote:

Hi there
 

I get SX/B notice me that SX key can't be found in COM port after few times of code writing.

Then SX key never work up anymore, how do I make sure SX key is funciton or dead?

 

and I also found a problem that same code running in debug mode and run mode has different result: 

  the byte value is different when sending out to RS-232. (the result running under debug mode is correct, but not in full run mode)

 Dose this happen? Or may I done things wrong? 

 

I am shifting from using BS2 to SX, anything I should notice?

 

Thanks.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=156919

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)