In SX Microcontrollers, SX/B Compiler and SX-Key Tool, metron9 wrote:

Just a quick look at it but are you not using bus lines with pullups? 

If so then you should have pins set low for both high and low signals and toggle the port direction from input (high signal) to output.low for the low signal. The basic stamp code uses HIGH CS_8255 where normally you would switch the output low on the CS to input highz to allow the pullups to pull the line high.

Like I said Its 2:30 and I am just trying to get out of here but I thought i would toss that out there.
 Gnight..

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=150716#m150783

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)