In SX Microcontrollers, SX/B Compiler and SX-Key Tool, ellizard wrote:

HI Everybody,

Just for information,
Where (apart on this forum's trhead) there are informations on the new command ANALOGIN?
I searched in the help window and there's no mention of such a command,
I searched also the What's new section of the SX basic and there's only
[quote"What's New In SX/B 1.51.03
-------------------------------------------------------------------------------
New Commands:
  LOOP NEVER
-------------------------------------------------------------------------------
Changes:
  Changed HIGH & LOW if a pin, set state again AFTER making it an output
-------------------------------------------------------------------------------
Fixes:
  Fixed: Literal replacement didn't handle strings in quotes
  Fixed: name CON -5 compiles as name CON 5

"][/quote]

This is all i could find about.
Please more informations needed

Regards
Stefano

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=149107#m149776

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)