=A0
Hello
    when i loaded a program to see if RX TX of UART and it works fine...i a=
m able to transmit and recieve data from the board


On Thu, 05 Oct 2006 Stef Mientki wrote :
>
>
>Binu Pillai wrote:
>
> >
> >yeh baud was checked it was fine too
> >
> >
>ok now check the protocol,
>tie 2 commports to the Tx and Rx lines
>and watch with something like hypertirminal what's happening.
>Stef
>
> >On Wed, 04 Oct 2006 stef mientki wrote :
> >
> >
> >>>yes i loaded a programme to transmitte 1,2,3....increasing order after=
 every second.
> >>>and another program that sends out 79 when i trasmit 24 from the PC
> >>>to test both RX and TX
> >>>
> >>>
> >>>
> >>did you check at the same baudrate as the bootloader is working ?
> >>did you try to send/receive complete strings ?
> >>
> >>
> >>>one board it starts then says time out. for all the attempts i made.
> >>>in all other board "searching for bootloader"
> >>>
> >>>
> >>>
> >>Could be a bad baudrate ...
> >>See my questions above.
> >>Stef
> >>
> >>--
> >>http://www.piclist.com PIC/SX FAQ & list archive
> >>View/change your membership options at
> >>http://mailman.mit.edu/mailman/listinfo/piclist
> >>
> >>
>
>--
>http://www.piclist.com PIC/SX FAQ & list archive
>View/change your membership options at
>http://mailman.mit.edu/mailman/listinfo/piclist
-- =

http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist