How do you tell which pin on the ICD chip is GPIO3?  I would think that you
could use the header outside of your circuit, or that it should at least
enter debug mode...?


On 10/3/06, WH Tan <whsiung.my@gmail.com> wrote:
>
> 2006/10/3, Shawn Wilton wrote:
>
> > I just noticed the debug exec on my ICD has no version info.  Could this
> be
> > the cause of my problems?  If so, how would I restore it on this little
> > header.
>
>
> Shawn,
>
> I just confirmed with mine, with MPLAB v7.41, it said 01.00.04.00 for
> debug executive.
>
> Just to confirm, as someone already pointed out in recent message, did
> you pull up GPIO3 to Vdd?  I means when the header is in your target
> circuit.  And if you use only the header alone, I think you might not
> get anything out of it since GPIO3 is not pulled to Vdd.
>
>
> Best regards,
>
> --
> WH Tan
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>



-- 

Shawn Wilton (b9 Systems)
http://b9Systems.com  <- New web page
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist