In SX Microcontrollers, SX/B Compiler and SX-Key Tool, kgracey wrote:

altitudeap-

The application is in cold country, so the SX's heat is welcome at 50 MHz!

To all:

The SX28AC/SS Proto Board's capacitors are adequate for driving servos. I'm powering a large 1/4 scale Futaba S3302 servo from the Proto Board's servo port and it works fine now. I also measure current draw of the servo and it was about 400 mA on startup, but runs about 300 mA in operation loaded with a small Honda engine throttle cable. 

Thanks to everybody. I'll be back to ask about interrupts Monday or Tuesday.

Ken Gracey
Parallax, Inc.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=147070#m147124

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)