In SX Microcontrollers, SX/B Compiler and SX-Key Tool, wbahn wrote:

Just got back from out of town.

It's a custom design, but someone that is quite experienced with the SX said my schematics are fine. I'm using a CMOS oscillator (which I can enable/disable with a jumper on the board). The footprint I used had the wrong width (too narrow) and so I had to really bend in the pins to get them onto the pads. My plan was to check it closely for shorts this weekend - and based on what has been said here that sounds like the most likely explanation. 

Thanks a lot and I'll report back on what I find.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=146281#m146915

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)