In SX Microcontrollers, SX/B Compiler and SX-Key Tool, peterverkaik wrote:

Thanks Bean.
I made a source for SX48, containing byte read/write and bit read/write routines
for both the general purpose ram and the special configuration registers.
I treat rambank0 registers as special configuration registers.

See the attached pdf for assigned config addresses.

The dynamic access to rambank0 requires a lot of code space (compared to the others)
so I think it is best to reserve rambank0 for a VP that runs in the isr. Then the
readRambank0 and writeRambank0 routines can be left out.

 

regards peter

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=146454#m146508

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)