Yeah, that's the document leaving me so confused.  It mentions that you
can't use the header to program your target device.  So I'm going to need
two cables?  One to go through the header and another to use with the RJ11
socket?



On 9/26/06, WH Tan <tanwh@notes.src.global.sharp.co.jp> wrote:
>
> Shawn,
>
> You should get 2 pieces of 4-pin gold plated stand-off connector.  Thing
> would be much easier if you used machined DIP IC socket on your target
> circuit.  So just plug the 2 stand-off connector into the socket on your
> target circuit.  The ICD2 header (the small PCB with a chip and RJ11 on
> it)
> should have an 8-pin DIP socket at the bottom side.  Align and confirm the
> orientation and plug it into the other end of the 2 4-pin header.  From
> now
> on, use ONLY the RJ11 socket on the header.  With the ICD2 header in
> place,
> NEVER use the ICD2 connection intended for a real chip, if you have one on
> your target circuit.
>
> I suppose you should have a printed copy of this, but just in case you
> don't
> have it:
> http://ww1.microchip.com/downloads/en/DeviceDoc/ICD2_Header_51292L.pdf
>
>
>
> Best regards,
>
> WH Tan
>
>
>
>
>
>
> > -----Original Message-----
> > From: piclist-bounces@mit.edu [mailto:piclist-bounces@mit.edu]On Behalf
> > Of Shawn Wilton
> > Sent: 27 September 2006 12:28
> > To: Microcontroller discussion list - Public.
> > Subject: Re: [PIC] Problem with PIC12F675 A/D conversion
> >
> >
> > OK, my ICD has arrived, and I'm trying to figure out how to hook the
> darn
> > thing up.  I can't find the docs needed to hook the ICD header for the
> > pic12f675 to my application.
> >
> > Nor can I figure out how to program my application.  I found some
> > app notes
> > that say you can't program when using the header, but you need
> > the header to
> > debug.  So since I program my application through a custom
> > firewire cable, I
> > suppose I will need two interface cables?  One for debug, and another
> for
> > programming since one will have to use the header and the other will
> not?
> >
> > Am I correct in my assertions?
> >
> >
> >
>
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>



-- 

Shawn Wilton (b9 Systems)
http://b9Systems.com  <- New web page
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist