> Yes, the same table that is used by an architect / mechanical 
> engineer would be cool.

I don't think so. I like my table to be fixed and flat, so it can have
holes for cabling to a below-the-table duct, and those small round SMD
don't roll down! And behind the table will be stands for tooling, books,
component cabinets etc, titling the table would obscure some of these!

If I need a higher table level (I am not sure this would be handy, but
it might be worth a try) I'd rather use a temporary 'table raiser' on
top of it.

Wouter van Ooijen

-- -------------------------------------------
Van Ooijen Technische Informatica: www.voti.nl
consultancy, development, PICmicro products
docent Hogeschool van Utrecht: www.voti.nl/hvu
 

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist