Great, I NEED GP1 and this is on a prefabbed board. Known alternatives? On 9/19/06, Per Linne wrote: > > A problem is that that header doesn't work too well either. > GP3 has to be configured for external /MCLR and > you cannot use GP1; it has to be grounded or the ICD2 > refuses to go into debug mode. So you only have 4 I/O > pins to play with. Amazing when they have a 14 pin chip > in the header. > > PerL > > > > ----- Original Message ----- > From: "Shawn Wilton" > To: "Microcontroller discussion list - Public." > Sent: Tuesday, September 19, 2006 6:27 PM > Subject: Re: [PIC] Problem with PIC12F675 A/D conversion > > > > Yeah, bit amazed that sweet little adapter is $25.00! > > > > But both have been ordered together. Thank you for the notification > though. > > > > > > > > On 9/19/06, WH Tan wrote: > >> > >> > >> On 19 September 2006, Shawn Wilton wrote: > >> > >> > Yeah, just went to put an order for an ICD2 in and m.com's page > f***ed > >> up > >> > and charged my card enough times to max it out. D'oh! Going to take > >> days > >> > getting this resolved... > >> > >> Just to save you some surprises when you get your ICD2: do you know > that > >> you'll need a special header to debug 12F675? > >> > >> > >> Best regards, > >> > >> WH Tan > >> > >> -- > >> http://www.piclist.com PIC/SX FAQ & list archive > >> View/change your membership options at > >> http://mailman.mit.edu/mailman/listinfo/piclist > >> > > > > > > > > -- > > > > Shawn Wilton (b9 Systems) > > http://b9Systems.com <- New web page > > -- > > http://www.piclist.com PIC/SX FAQ & list archive > > View/change your membership options at > > http://mailman.mit.edu/mailman/listinfo/piclist > > > > -- > http://www.piclist.com PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist > -- Shawn Wilton (b9 Systems) http://b9Systems.com <- New web page -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist