----- Original Message ----- 
From: "Jan-Erik Soderholm" <jan-erik.soderholm@telia.com>
To: <piclist@mit.edu>
Sent: Tuesday, September 19, 2006 7:29 PM
Subject: RE: [PIC] pogram upload, again


> Frank Abbing wrote :
>
>> Next problem: how
>> to program a programmer.
>> I found how to do that, it means getting another 16F628 +
>> some surrounding hardware. Have I got that right?
>
> If you've got a working Wisp628 (using the "voti-standard"
> 1.09 formware), you just use that to program another 628A
> with the 1.10 (or 1.11) firmware from Rob. Then power down
> and swap chips. The old 1.09 chip can be saved until the next
> formware update...
>
> After the 1.10/1.11 have been installed, your Wisp628
> supports the 18F chip you're using.
>
> And I'd recomend XWisp2, easy to use and fast.
>
> Regards,
> Jan-Erik.

I tried using xwisp2. Because I have not yet updated the firmware it gave me 
a mysterious error message. Now it is clear to me why! Thank you all 
(Wouter, Rob & Jan-Erik)

Frank Abbing 

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist