Hi List,

I'm working on a test fixture that uses a small PCB that would plug into a 
28-pin DIP socket (for use by the QA people). The problem is, if I use 
standard 0.1" header pins, they deform the solder tail pins and I'm afraid 
that they won't make good contact with the real chip's pins.

Any ideas where I can find pins with the correct form factor?

Best regards,

Vitaliy 

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist