I am trying to use an EasyProg to program an 18F4520 in circuit using the
ICSP jack on the side.  When I run pic_prog with no parameters, I get:

Firmware is type EasyProg version 12 by Embed Inc.
No information was found for a PIC with device ID word 65.  This chip is not
supported.
*** Program aborted on error. ***

When I run test_picprg and execute in ID command, I get:

: id
ID Namespace 16 bit "high end" core, 0000000001000001b 0041h 65

I am guessing that this indicates that communication is working.  I am not
sure why pic_prog doesn't recognize it.  I checked the website, and the
18F4520 is listed as supported.

FWIW:  I am using the QFP version of the chip, 44 pin.  Anything I am
missing?  Do I need to update my firmware?

Thanks for any advice!

--Joe Jansen
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist