OK, then I will not find out something that has already been invented :-)

Tamas

On 17/08/06, Tony Smith <ajsmith@rivernet.com.au> wrote:
>
> > Well, there are lots of flow chart generators -- maybe not
> > for PIC programming , but there are some very expensive
> > softwares that do that. But all of them are converting a
> > program listing to a flow chart or generates program listings
> > from that. Which I meant is a 'native' flowchart, so that
> > when you would say 'BCF GPIO,5' you would put the relevant
> > function box or whatever instead like:
>
>
> The www.picaxe.com software is what you describe, as was the IBM system.
> Screenshot on their website -
> http://www.rev-ed.co.uk/picaxe/images/editorbig.jpg - looks like your
> ASCII
> one  :)
>
> For PicAxe, the commands are at the lowest level, so each box is a single
> command.  The IBM software could have subroutines, double clicking that
> box
> brought up its flowchart.
>
> You don't get assembly, the program gets converted to tokens & downloaded
> (RS232) to the chip.  Naturally, it runs a lot slower than a compiled
> Basic
> or native assembler.  The editor is a 26 meg download.
>
> The PicAxe is a PIC chip, either an 8-pin (16F629A), 18-pin (16F628A) or
> 28-pin (can't remember).
>
> Tony
>
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>



-- 
unPIC -- The PIC Disassembler
http://unpic.sourceforge.net
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist