Maybe....don't use a rotary switch but some sort of simple RF link with bri= ght LEDs and a clear cover box...so they can see the specific color LED and= they know if its in the left or center or right...."mode" = IP66 is a tough one, most industrial switches only rate to IP65 Steven Howes wrote: = > Waterproof (IP66) switches tend to be used for isolation, so on/off only - > the nearest I've found is: > = > http://www.mastervolt.com/product.asp?ID=3D1059&rd=3Dce4N0 > = > which isn't rotary, but does have three positions: on / off / on and it's > waterproof! Not sure if this would be any good to you. What = > sort of switching are you doing? Is it really one to one-of-three? Basically the central position will be 'off'. The left hand side will connect a ground on 'circuit 1', turning it to the right will connect the ground for 'circuit 1' and 'circuit 2'. And this device could be submerged in a metre of water for several minutes. The currents it will draw will be at the very most an amp, although it will most probably be nearer 700mA. The person operating it probably wont be able to see it so we were after a nice clicky rotary switch with 3 definite positions. Thanks again Steve -- = http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist = --------------------------------- How low will we go? Check out Yahoo! Messenger=92s low PC-to-Phone call ra= tes. -- = http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist