In SX Microcontrollers, SX/B Compiler and SX-Key Tool, ahunter10 wrote:

Hello, i'm new to the SX, and i have a simple question that i can't figure out.

I would like to use code similar to the following:
[code]
for idx = 0 to 7
     HIGH RA.idx
next
[/code]
I would like to use a variable to identify a pin.  But this code doesn't work.  Is there some way i can get something like this to work, without using if-then statements?

Thanks,
Alex Hunter

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=138451

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)